Driver osst needs updating

APIC timer calibration result 12564386 Detected 12.564 MHz APIC timer.SMP alternatives: switching to SMP code Booting processor 1/2 APIC 0x1 Initializing CPU#1 Calibrating delay using timer specific routine..Once you know the kind of graphics card you have, visit the manufacturer's website to download the latest driver.Here are links for downloading drivers from the most common graphics card manufacturers: If you upgraded your driver to resolve a display issue, and it didn't resolve the issue, you may consider installing an older driver for your graphics card instead.my DMESG output Linux version 2.6.24.4 ([email protected]) (gcc version 4.2.3 (Gentoo 4.2.3 p1.0)) #3 SMP Tue May 20 EST 2008 Command line: root=/dev/hda3 pci=routeirq BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009f000 (usable) BIOS-e820: 000000000009f000 - 00000000000a0000 (reserved) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000007fff0000 (usable) BIOS-e820: 000000007fff0000 - 000000007fff3000 (ACPI NVS) BIOS-e820: 000000007fff3000 - 0000000080000000 (ACPI data) BIOS-e820: 00000000f0000000 - 00000000f4000000 (reserved) BIOS-e820: 00000000fec00000 - 0000000100000000 (reserved) Entering add_active_range(0, 0, 159) 0 entries of 256 used Entering add_active_range(0, 256, 524272) 1 entries of 256 used end_pfn_map = 1048576 DMI 2.4 present. Console: colour VGA 80x25 console [tty0] enabled Dentry cache hash table entries: 262144 (order: 9, 2097152 bytes) Inode-cache hash table entries: 131072 (order: 8, 1048576 bytes) Checking aperture...

PCI0._PRT] ACPI: PCI Interrupt Routing Table [\_SB_. HUB0._PRT] ACPI: PCI Interrupt Link [LNK1] (IRQs 5 7 9 10 11 14 15) *0, disabled.Here is the response when trying to find its status: ****@****-Ubuntu:~$ mt -f /dev/st0 status mt: /dev/st0: rmtopen failed: Input/output error Here is the result of trying to mount the drive using KDat: There appears to be no tape in the drive /dev/st0.Please check "Edit Preferences" to make sure the correct device is selected as the tape drive (e.g. If you hear the tape drive moving, wait until it stops and then try mounting it again.I don't know even there was something like tape drive on Linux, but..."sudo blkid" "mount" I would be using to check if device is detected by Linux and if it is mounted somewhere already. I'm not completely finished with working this out on one of our DL 380 G4 servers, however if you want to jump start your drive not getting recognized, this is what I am doing - so far.